To start with, any new tank, you're level will never be low in ammonia or
nitrtites/nitrates for quite a while, usually 3 weeks for a complete cycle,
enough time for the benefical bacteria to develope and "eat" the ammonia
nitrites. Chloramine in itself will not affect ammonia. So, that leaves a
couple things.
First, if you're using ammo-lock, stop. You'll be curing the problem at hand
for a short while, but your system will become dependant on it.
Next, leave your tank be for a while after you change the water and treat
it. I've seen people doing daily water changes every day for a month and
wondering why there's still ammonia... because the benificial bacteria
hasn't even has a chance to start growing.
Yes, ammonia and nitrites/nitrates arent healthy for a fish in heavy
quantities, but quite a few fish can tolerate it for quite a while without
permanant damage.
I'm no expert by no means, but this is what I would do.
1. Do a 20% change and pretend this is a new tank. When refilling the water,
rumor has it that it's safer to use a double dose of declor to remove
chloramines.
2. Don't touch the filter, if it's plugged with gunk, syphon some tank water
to clean it. Do not wash it under the tap.
3. Control feeding. Fish pretend they're hungry 24 hours a day,
realistically once or twice a day is fine, with the general rule of thumb,
as much as they can eat in 5 minutes. If you have an accident, overfeed,
just syphon the excess out, same as if you see any build up on the bottom of
the tank, just clean the small messes up.
4. Every third day, vacuum the gravel until you're removed the 20% water
volume, and refill as normal with declored water.
Now keep an eye on the ammonia levels, I've had mine off the scale a couple
time on newly set up tanks, and just do a quick change to bring them back
down a bit. Determining what a fish can tolerate is strictly in the owners
point of veiw. Higher pH can make the ammonia more toxic to the fish. Fish
will show tell-tale signs if they can't handle the level of ammonia, and as
soon as they show it, something has to be done to bring the level back down
right away.
Once the bacteria starts growing, the bacteria will double daily on the
amount of food it has available, which is the ammonia and nit's.
This bacteria will grow in your filter, in the gravel, on plants, in the
water, everywhere in the tank.
Eventually the ammonia level should disappear to nothing as the bacteria
grows.
Good example, there's people that do fishless cycles, they dump high amounts
of ammonia in the water, and viola, beneficial bacteria forms and clears it
out.
Again, I'm no expert by no means, just my point of view on this.
Cheers
<LadySamsara DeleteThis @webtv.net> wrote in message
news:25215-3EF5F33E-113@storefull-2236.public.lawson.webtv.net...
> Thanks for all of the replies. I'll try to explain my water
> conditions...but still being fairly new, maybe I am missing something.
> I hope somebody can point me in the right direction.
>
> Prior to my water supply company adding chloramines I never had any
> problems. I used the dechlorinator and all was fine. Then they added
> the chloramines and the LFS suggested using Ammo-Lock. This was about
> the time I set up my 10 gallon tank, and when I brought the water to be
> tested it showed high levels of ammonia, after using the dechlor. and
> prior to adding any fish. During the cycle it was suggested I do
> partial water changes to bring down the ammonia when it spiked real
> high. The gal at the LFS said the water company was blasting the water
> with chloramines and the water changes were making the ammonia worse.
> She suggested the bottled spring water, which I have been using ever
> since (November 2002). I have a 10 gallon tank and 3 Betta tanks, I go
> through about 9 gallons a week (2 Betta tanks are unfiltered and
> require full weekly water changes).
>
> I considered using the tap water after I moved, even though it too
> contained chloramines. I let it age a few weeks, then added the
> appropriate amount of dechlor. (I tried both Amquel and Tetra Aqua
> Safe). I tested it and high ammonia readings came back. Am I missing
> something? Should it show high levels of ammonia after being treated?
> I have the AP test tube kit.
>
> I do hope someone can help me here....I am getting frustrated lugging
> all this water from the store and making sure I always have it on hand.
> Is there a way I can safely use my tap water? (Sorry if I rambled...as
> I said I really don't understand the whole water thing too well). Thank
> you!
> >> Stay informed about: R.0. Water